Am I the only one? - dodgy Hotpoint TDC32P?

TDC32P Any Ideas? My TDC32P condenser keeps cutting out after a minute of running. It seems to run normally ie gets warm, rotates etc but keeps stopping for no apparent reason. So far I've changed ... more

done

Hotpoint First Edition 1000 intermittent start?

My Hotpoint First Edition 1000 has become a little unreliabe on starting. Irrespective of the cycle setting the machine has been taking progressively longer to start after the power switch has been d ... more

done

E2 fault code on BF72?

i get E2 fault code on my Creda/Hotpoint BF72 dishwasher. The manual says this is due to the level safety device tripping. Does anyone know how to reset the trip? cheers

done

Hotpoint WM64 Does not pump out all water and/or spin properly?

The Hotpoint WM64 completes the wash cycle but the clothes are wet on completion of the rinse/spin cycle and remaining water appears to be soapy. Is there a filter on this machine that may need cleani ... more

done

Water doesn't drain out of my hotpoint WM66 can I fix it?

I have a Hotpoint washing machine which is spinning but not draining? Would this be the pump or the filter? Is it something that I would beable to fix. If so how?

done

Hotpoint FF71 Fridge/freezer thermisters?

Thanks Ian. There are two thermisters that plug into the rear panel. One green plug and one yellow plug. Do you know which one causes the fault or should I replace the both?

done

I have a hotpoint aquarius 1200 wont drain?

I have replaced the pump and cleaned filters etc, so its on the electrical side ...can anyone help?

done

Hotpoint TC71 blowing cold?

As a person who knows absolutely nothing about repairing a Tumble Dryer, how do I go about repairing my Hotpoint TC71? It is blowing cold. Please could anyone advise me what may need replacing and w ... more

done

will the motor from a hotpoint wm64 fit a wm63 machine?

motor gone in wm 63 can I use wm64 as a replacement

done

Hotpoint FF71 frost-free fridge/freezer?

My frost-free fridge/freezer is building up too much ice at the rear of the freezer. So much that it is blocking off the air flow to the fridge, so it's far too warm in the fridge. The fan is working ... more

done

how can i fix my hotpoint aquarius wma35 1100spin?

my washing machine does not seem to spin cloths dryer enough for (separate) dryer this leaving pool of water runnig from dryer please help

done

How can I fix my hotpoint WM64 - drum not turning by hand?

The metal drum of my hotpoint Aquarius 1200 WM64 stopped turning during wash and I couldn't rotate the drum even a little bit by hand - looks not like socks jammed between the drum and the plastic cas ... more

done

What is wrong with my hotpoint?

I don't know what is wrong with my hotpoint, it only produces cold air, no hot air? What is wrong with it? and how much will it cost to fix it? thanks

done

How can I cure flooding from Hotpoint 9536 ?

Machine sometimes floods large volume of soapy water from powder dispenser. I've cleaned dispenser thoroughly which seemed to stop problem for a while, but perhaps that was just coincidence. Can anyon ... more

done

How do I tighten the belt for my Hotpoint 9330 reversomatic tumble dryer?

We've managed to fit the belt over the drum and the pulleys but it is still slightly slack how do you tighten the belt so it is snug to the drum. Can you also let us know if we have fitted it correctl ... more

done

a wire on limited edition hotpoint 1000 wm52?

a brown wire attached to the door has come off from its other end we thought we knew where it went but there is no power could you please help me

done

Hotpoint Ultima 1400 wma60?

the tap simble on my washing machine flashes, with a beeping sound, when the machine goes onto rinse mode. what does this mean as the programme will not move on.

done

I have a Do Do I need to remove motor from machine before removing brushes?

I have a Hotpoint Aquarius WM63 washing machine that is emptying but not agitating nor spinning, I suspect I need to replace the brushes but firstly do I have to remove the motor from the machine or c ... more

done

How do I change the bearing on my Hotpoint WMA33?

How do I change the bearing on my Hotpoint WMA33

done

hotpoint wm51?

the door light doesnt come on when the door is closed how do i fix it?

done