How can I fix Sears Tower Bell and H. super auto threading 8mm projector?

Model 584-92820 The top reel will not spin to feed the film. It is firmly attached and in 'forward'. Bell and Howell super 8mm movie projector with auto threading. Manual threading and attaching to bo ... more

Sears du all 8mm projector?

Looking for instructions on how to thread a Sears Du-All Eight 8mm projector. Model 584-92040.

done

How to replace light part in Kenmore Vacuum 11625915507 Telescoping Wand?

Purchased the replacement part from Sears and there is no directions in manual or with part. The light comes attached to what appears like a large circuit board and I have no idea how this large piece ... more

How to replace Walk Belt on a Sears Treadmill Extend 831 TREADMILL?

How to Replace the Walk Belt on a Sears Lifestyler Extend 831 Treadmill

Kenmore vacuum repair?

Where can I take a Sears Whispertone 100 vacuum to be repaired near the 12208 zip code area>

How to use a Sears Robuck & Co. Clamp on file guide?

What are the user instructions for a Sears Robuck & Co. Clamp on File-n-Guide Model No. 32-36508

done

Calibrating Sears Freespirit Mod.# 122 300811?

Replaced blown 15A fuse in lower control board. Treadmill ran for short while then quit. Display reads CAL with E3 error. What is the procedure for calibrating this treadmill. Thanks.

done

How to change motor in a sears kenmore canister vacuum?

How to change a motor in a sears kenmore canister vacuum

Gas Clothes Dryer Series 80?

Replace belt on Sears gas clothes dryer.

My sears treadmill slows down to nothing, when I step on it?

I have a sears tread mill and it works fine, except when I go to get on it and it's running it slows down to nothing, no matter how fast I have it running.

Sears 22in 6.75hp wheeled weedtrimmer?

how do I install parts - extension spring, govenor link and throttle link? My manual does not show how to install parts. A detailed diagram would be helpful. Thanks for help.

lifters?

craftsman model 917271080 engine model cv16s been all over the web and cannot find any sources that offer lifters for this model. sears sight is no good wont even recognize this model number. other si ... more

done

give me ideas?

My refrig Whirlpool model #10657989700 was chilling and then stop I had sears look at and they said it was the thermostat. I bought the part was going to put in myself but I made mistake and touch the ... more

done

What is error E1 on 2006 Sears Free spirit treadmill?

I plug the treadmill into AC power and the motor does a very a small movement, not even a 1/4 turn. Then I press the "start" button. The time counter runs for about 11 seconds and stops. The cod ... more

disassemble a sears model 116.22812205?

My power cord is stuck inside. I need to disassemble my 116.22812205 sears canister vacuum to correct. How do I do that?

done

blade gard?

The blade guard broke the arm on the side went as well. If I could find the used parts would be fine. and how its attached. Its a sears model 17 1/4 inch 13.283400c sliding chop saw

crftsman rear tine tiller m#917294482 wheels not engaging. tines engage?

I dont think my Tiller qualifies as a lawn mower but its not any of the things on the list so i put it here. And..Since theres no room for my question in the box where it says to type it..which seems ... more

done

My Sears sewing machine will only sew in reverse..feed dogs are not moving ?

when I try to sew the feed dogs dont grab the material. only in reverse do the work properly,Karen P.

sears kenmore washwer spinning but not drying enough model 11.25652400?

Kenmore washer model 110.25652400 still coming out too wet after spin cycle, seems to be spinning but doesn't work all the time and is getting worse.

Sears Free Spirit Treadmill won't start?

My old Free Spirit treadmill just stop yesterday and won't start again. I unplug, reset, replug, nothing. The timer and display goes on, timer start and after 10 second I get a l5 error. The belt do n ... more